Customer Cars
Ray Decker
Removed and reinstalled motor twice (separate occasions). Installed clutch, Greddy TD06,
Greddy IC, and Supra fuel pump.
Dan Bryant
Installed clutch, helped with Greddy IC, AFC, and TD06 install, dyno tuned car with AFC.
Patrick Wright
Removed original motor, installed clutch and intercooler, completed CT26 upgrade.
Brian Y.
Replaced VPC temp sensor and knock sensor.
Jon Freund
Installed rear brake pads.
Aaron Wiser
Removed original motor. Installed built motor with TD06, FPR, HUX rail, VPC, AFC, clutch,
Greddy intercooler, Supra fuel pump, gauges, springs, and struts. Did break-in of motor
and preliminary dyno tuning with AFC/VPC combo.
Mike Ko
Removed original motor. Installed built motor with T67, VPC, AFC, ITC, clutch, and Spearco intercooler.
Did break-in of motor and dyno tuning with AFC/VPC combo.
Ryan Price
(round 1) Removed original motor. Installed built motor with GT3037, AFC, clutch, Spearco intercooler,
Supra fuel pump, gauges, and stainless brake lines. Did break-in of new motor and dyno tuning
with AFC before and after.
Chee Xiong
Removed original motor. Installed built motor with GT3037, clutch, Spearco intercooler, Supra
fuel pump, and gauges. Did break-in of new motor.
Ramon E.
Installed AFC, HKS 264 degree cams, and Spearco Intercooler. Did dyno tuning of TD06. Did dyno
tuning of JDM motor with CT26 with AFC.
Dan Roush
Removed original motor. Installed flywheel, clutch, hose from hell, Spearco intercooler, and
93 manifold with CT26 upgrade.
Alex D.
Finished poor motor install. Installed Spearco Intercooler, T3T4 kit, VPC, AFC. Did initial
break-in of new motor.
Reuben Espillat
Dyno tuned car with VPC/AFC combo.
Justin Clements
(MKI MR2) Installed valve cover gasket and distributor oil ring.
Garrett Schiller
Installed Hux Rail, 850cc injectors, TRD regulator, and Electromotive TEC3. Dyno tuned car
on AFC and later with TEC3.
Dyno Sheet
Osman Ullah
Removed original motor. Installed new timing belt, water pump, and clutch. Cleaned motor.
Ryan Price
(round 2: new car) Installed 3rd generation 3S-GTE with GT3040 kit, Apexi IC, Tial wastegate
and BOV, and OS Geiken twin plate clutch. Fabricated custom intercooler pipes and intake.
Rewired the car for the 3rd Gen ECU and JDM 95+ tailights.
James Wight II
Finished assembly of long block. Degreed the HKS 264 cams. Installed GT3037 turbo kit,
Greddy IC, ACT 6 puck clutch, Apexi AVCR boost controller, ST anti-sway bars, and
motor/tranny in car. Did intial break-in and associated oil changes.
Felipe Villalobos
Dyno tuned car with Power FC.
Dave Wilkinson
Diagnosed and fixed problem with car, swapped out fuel pump, and did cam gear tuning on
the dyno.
Jeff Fazio
Installed HKS VPC, Apexi S-AFC, MSD 6AL with dual stage rev limiter. Dyno tuned car.
Dave Chang
Installed Hux rail, 72lbhr injectors, SX Fuel Pressure regulator, and Electromotive TEC2.
Street and dyno tuned car.
Dyno Sheet
Ryan Price
(Round 3) Full standalone tune. Replace broken exhaust manifold. Remove GT3040 kit, replace with GT3037 kit. Install HKS fuel system. Fabricate and install custom intercooler piping.
Dyno Sheet
1/4 Mile Time Slip
Jensen Lum
Full standalone tune.
Dyno Sheet
Kris Osheim
Full standalone tune.
David Vespremi
Full standalone tune.
Dyno Sheet
Ken Blake
Street tuned car for driveability.